D-F

Feed Rate
This describes the speed at which motion axes move, usually in mm/s and can refer to the X, Y, Z and extruder ‘axes’
Fri, 15 May, 2015 at 2:34 PM
Feedstock
See filament.
Mon, 24 Aug, 2015 at 11:06 AM
FFF
Fused Filament Fabrication. Where a filament of one material (plastic, wax, metal, etc.) is deposited on top of or alongside the same (or similar) materia...
Fri, 15 May, 2015 at 2:35 PM
Filament
The ‘feedstock’ for a FFF 3D printer - a thermoplastic which has been extruded into a 1.75mm diameter ‘wire’ which is fed to the print head and melted bef...
Fri, 15 May, 2015 at 2:35 PM
Filament Slip
'Filament Slip' is the term we use to describe an issue with feeding filament. Inside the extruder (filament feeder), there is a wheel with a rubb...
Thu, 14 May, 2015 at 4:10 PM
Fill
This describes all extruded material on the inside of a printed object. It’s density can be varied (as a percentage) between fully hollow and fully solid ...
Fri, 15 May, 2015 at 2:37 PM
Fill Density
This describes the density of the fill - 0% for a hollow object, 100% for a fully solid object.
Fri, 15 May, 2015 at 2:36 PM
Firmware
This is the computer program which runs on the hardware itself and is stored in flash memory on the mainboard.
Fri, 15 May, 2015 at 2:37 PM
Flash Storage
This refers to the storage available on Robox® to store GCode print instructions during printing. It also maintains a history of previous prints, allowing...
Fri, 15 May, 2015 at 2:38 PM
Flow Rate
This describes the rate of extrusion from the nozzle - normally measured in mm³/s
Fri, 15 May, 2015 at 2:38 PM